6. Attach the side plate to the module by snapping the plastic clips on the
plate into the two slots on the module.
NOTE:
If the side plate must be removed, use a small, flat object
(such as a flat-head screwdriver) to carefully pry the plastic clips on
the side plate off of the module near the two slots.
7. Feed the other end of the cable through an empty module slot in the
FT2-700 assembly.
8. Slide the pass-through cable module into the same module slot as
mentioned in the previous step. Use the guide ribs on the front and
rear of each module to help position the module in the FT2-700
assembly.
Install the Blank and Keystone Plate Module
Four blank plate modules are included to fill empty slots in module rows. A
keystone plate (sold separately) module allows for cables terminated with
standard keystone jacks to be installed in the FT2-700 assembly. The
blank and keystone modules each require one empty module slot for
installation.
Blank and Keystone Plate Modules
To install a blank or keystone plate module into the FT2-700 assembly:
l
Slide the blank plate module down into the appropriate module slot.
Use the guide ribs on the front and rear of each module to help
position it in the FT2-700 assembly.
l
For the keystone plate module, complete the following steps.
1. Snap the cable’s keystone jack into the keystone opening in the
keystone plate module.
2. Feed the cable down through the empty module slot.
3. Slide the attached keystone plate module down into the same
module slot using the front and rear guide ribs to assist with
positioning.
6
FT2-700-MECH Series
Quick Start
FlipTop™ FT2 Series, 700 Size, Mechanical
