Level the Shade Fabric
The shades are leveled by rotating the ring on the idler or intermediate
band. To properly level the fabric, raise the fabric above the adjacent
fabric and then lower into place.
NOTES:
l
Before leveling the fabric, run the shades through two full open and
close cycles to allow for the fabric to settle on the tube.
l
Leveling must be performed with the bottom of the shade fabric at
eye level.
1. Hold the drive band stationary.
2. Use the spanner wrench on the idler band, or the first intermediate
band next to the motor band, and rotate the ring so that the fabric
travels approximately 2 in. (51 mm) above the adjacent fabric.
3. Use the spanner wrench to lower the fabric until it is lower than the
adjacent fabric.
Lower the Fabric so that it is Lower than the Adjacent Fabric
7
CSA-DECOR5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
