NOTES:
l
The pin is not fully extended until the white part of the pin is showing.
l
If the white part of the pin is showing and the two bands are not
engaged, the brackets are not installed at the dimensions entered in
the Crestron Design Tool (CDT).
l
During the installation of coupled shades, the fabric does not need to
be level. The fabric is leveled after installation. Leveling the fabric is
easier if all of the fabric is close in location.
Coupled Shade Installation Example
1. Use the spanner wrench to extend the pin on the motor band to the
half-extended position.
2. Make sure that the bushing is oriented vertically to receive the pin, and
then slide the half-extended pin into the bushing.
3. Raise the motor end and secure it to the motor bracket. Refer to
Mount the Roller Shade Assembly
for details.
4. Mount the next band.
l
If the next band is being installed into a coupler, insert the half-
extended retractable pin into the next coupler.
l
If the next band is being installed into an idler bracket, insert the
idler band’s idler pin into the idler bracket.
5. Raise the idler or intermediate band and align it with the coupler.
6. Use the spanner wrench to extend the pin so that it fully inserts into
the next band. To make sure that the pin engages fully into the mating
band, lightly lift the two bands upwards to relieve the weight on the pin
so it can slide fully into the hole. This requires two people. The idler or
intermediate band might need to be rotated to allow the pin to
properly enter the band. Once the pin is fully inserted, check to see that
the white shoulder of the pin is visible on the idler or intermediate band
side of the coupler. The idler or intermediate band should not be able to
rotate once the pin is fully extended.
Pin Extended Through Coupler into Idler or Intermediate Band
6
CSA-DECOR5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
