Crestron CNXRMCLV, Руководство по эксплуатации

Страница: 19 / 40

Crestron CNXRMCLV Room Solution Box with Local Video
Operations Guide – DOC. 8161A Room Solution Box with Local Video: CNXRMCLV
•
15
NOTE: Typically, codes used by Magnavox, Marantz, and Philips audio/video
equipment utilize RC5 codes for transmission. Some codes used by Sharp
Electronics Corporation are also usable.
Universal remotes require two
multi-step procedures for setup.
Some devices from Magnavox, Marantz, and Philips are designed to understand
certain kinds of infrared signals sent by remote controls, specifically, signals
belonging to the RC5 code set. Two procedures are required to setup a universal
remote. The first procedure verifies that the universal remote chosen does transmit
an identifiable code and therefore can communicate with the CNXRMCLV. The
second procedure maps the buttons on the universal remote so that they can be used
in the SIMPL Windows program.
Code Verification
Refer to the note on page 26 for a
definition of Viewport.
Each universal remote comes with its own manual, which lists codes by device and
manufacturer. The purpose of this procedure is to select and program a code into the
universal remote so that it can communicate with the CNXRMCLV. All that is
required to complete this procedure is the CNXRMCLV, a Crestron CNXRMIRD, a
PC running the Crestron Viewport, a Crestron control system connected to the PC,
and any universal remote (complete with batteries and manufacturer's manual). The
control system should be running a valid SIMPL Windows program that includes
the CNXRMCLV (at the proper Net ID so that the CNXRMCLV can be polled) and
a CNXRMIRD. (For details on including the CNXRMIRD in the program, refer to
“Receiver” on page 21.)
1. Attach the CNXRMIRD to the CNXRMCLV (IR IN port).
2. Using Cresnet cable, attach the Crestron control system to the
CNXMRCLV (NET port). Refer to "Network Wiring" on page 8 for
details.
3. Open the Crestron Viewport.
Either launch the stand-alone version of Viewport, or start SIMPL
Windows and from the menu bar, select
Tools | Viewport.
4. From the Viewport menu, select Diagnostic | Identify Transmitter
ID . The software checks the baud rate and then opens the "Transmitter
Identification" window, as shown after this step.
"Transmitter Identification" Window
5. Point the universal remote at the CNXRMIRD and program the remote
with an RC5 code (some Sharp codes are acceptable as well) as
outlined in the manufacturer's manual.
NOTE: Crestron recommends that codes from manufacturers other than the
manufacturer of the device being controlled be used to avoid IR transmission
conflict. For example, if the controlled device is a Sony DVD player, an acceptable
code from any manufacturer (except Sony) should be used to communicate with the
Sony DVD player via the CNXRMCLV.