Crestron CEN-TVAV, Руководство по эксплуатации

Страница: 8 / 52

Ethernet Enabled Programmable TV/AV Controller Crestron CEN-TVAV
This 8-pin, 8-position RJ45 port connects the CEN-TVAV to a 10BaseT
Ethernet/LAN or WAN via a hub. Refer to the table below for the pinouts. A
standard (straight, non-cross-over type) Ethernet cable is required but not supplied.
NOTE: This port should NOT be connected to the UPLINK port of an Ethernet hub.
Ethernet Port Pinouts
PIN DESCRIPTION PIN DESCRIPTION
1 TX- (Transmit -) 5 Not Connected
2 TX+ (Tr) 6 RX- (Receive -)
3 RX+ (R) 7 Not Connected
4 Not Connected 8 Not Connected
CRESNET
This 6-pin, 6-position RJ11 modular jack is used to connect the CEN-TVAV to a
control system so it may be accessed as a Cresnet peripheral. Refer to the table
below for the pinouts.
CAUTION: If making connections to RJ11 ports, use the Crestron 6-conductor
modular cable provided, DO NOT use 6-conductor telephone cables. Telephone
cables are wired in a crisscross fashion and are not compatible with Crestron
equipment. For further information, refer to the latest revision of Modular Cable
Requirements (Doc. 5682). This document can be obtained from the Downloads
page (CABLES and MANUAL Libraries) of Crestron’s website
(
www.crestron.com) . Search for MODULAR.PDF. New users are required to
register in order to obtain access to the FTP site.
NOTE: This port does NOT provide 24 direct current volts (VDC) for powering
other equipment.
CRESNET Port Pinouts
PIN DESCRIPTION PIN DESCRIPTION
1 Not Connected 4 NET- (Cresnet Z data)
2 Not Connected 5 GND
3 NET+ (Cresnet Y data) 6 GND
RS-232
This 6-pin, 6-position RJ11 modular jack is used for control of RS-232 peripheral
devices and to communicate with a personal computer (PC) when programming the
CEN-TVAV. Prior to switching between the programming mode and the RS-232
port, refer to “Special Considerations for Using the RS-232 Port for Uploading
Programs” on page 9. Refer to the table below for the pinouts.
RS-232 (PC) Port Pinouts
PIN DESCRIPTION PIN DESCRIPTION
1 CTS (Clear to Send) 4 TxD (Transmitted Data)
2 GND 5 RTS (Request to Send)
3 RxD (Received Data) 6 Not Connected
I/O (1-4, G)
Pins 1-4 of this Versiport may individually be used as programmable digital inputs,
digital outputs, analog inputs, or any combination of each. Digital inputs are rated 0 -
4
•
Ethernet Enabled Programmable TV/AV Controller: CEN-TVAV Operations Guide - DOC. 5720A