Crestron
CEN-TVAV
Ethernet Enabled Programmable TV/AV Controller
NOTE:
The RJ11 to DB9F adapter is available commercially or contact Crestron
customer support for part number 15556.
NOTE:
If an RJ11 to DB9F adapter and/or modular cables are not available, refer to
“Programming Cable Fabrication Specifications” on page 9.
Typical Connections when Programming
CRESNET
ETHERNET
RS-232
IR
6.6A MAX
50-60HZ
115 VAC
POWER OUT 6A MAX
POWER IN
CRESTRON ELECTRONICS INC. ROCKLEIGH, N.J. 07647 USA
I/O
1 2 3 4 G
TO PC DURING
PROGRAMMING
TO VAC
OUTLET
TO TOUCHPANEL
DURING
PROGRAMMING
1. Attach the RJ11 to DB9F adapter to one end of the 6-conductor
modular cable. (Not required if a PC to control processor cable is
fabricated.)
2. Attach the RJ11 connector (of the adapter and cable combination) to
the
RS-232
port.
3. Attach the DB9 connector (of the adapter and cable combination) to an
available
COM
port on the PC.
4. Attach the RJ11 connector of the modular cable supplied with the
touchpanel (or fabricated touchpanel to control processor cable) to the
CEN-TVAV port labeled
CRESNET
.
NOTE
: The CRESNET port of the CEN-TVAV does
NOT
provide 24VDC for
touchpanel operating power. The touchpanel must receive power from either a
supplied external power pack or an internal battery.
5. Attach the other connector of the modular (or fabricated) cable to the
touchpanel.
6. Plug CEN-TVAV power cord into VAC wall outlet or power strip.
Programming Cable Fabrication Specifications
In the event that modular cables or RJ11 to DB9F adapter is not available to program
the CEN-TVAV at the RS-232 port, the table and diagram on the next page are
provided so that the cable can be fabricated.
NOTE:
The RJ11 to DB9F adapter is available commercially or contact Crestron
customer service for part number 15556.
Operations Guide - DOC. 5720A
Ethernet Enabled Programmable TV/AV Controller: CEN-TVAV
•
9
