Crestron C2N-TFM, Руководство по эксплуатации

Страница: 29 / 48

Crestron C2N-TFM FM Radio Tuner
Operations Guide - DOC. 6233A FM Radio Tuner: C2N-TFM
•
25
C2N-TFM FM Tuner RDS Information Input and Output Signal Descriptions
SIGNAL TYPE AND
NAME DESCRIPTION
Analog input:
<
EventFlags >
Each FM RDS/RBDS report code can be enabled
or disabled by setting the individual bits to high
(enable) or low (disable).
Bit0 = PI Code report - not supported Bit1 = PTY
(Program Type) Code report - enabled by default
Bit2 = PS (Program Service) Code report code -
enabled by default
Bit3 = Extended Country Code report - not
supported
Bit4 = Language Code report - not supported
Bit5 = Emergency Channel Code report - not
supported
Bit6 = Clock Year Code report - enabled by default
Bit7 = Clock Month Code report - enabled by
default
Bit8 = Clock Day Code report - enabled by default
Bit9 = Clock Hour Code report - enabled by default
Bit10 = Clock Minute Code report - enabled by
default
Bit11 = Clock Offset Code report - enabled by
default
Bit12 = Radio Text report - enabled by default
Bit13 = PTYN (Program Type Name) Text report -
enabled by default
Bit14 = TA (Traffic Announcement) Code report -
enabled by default
Bit15 = TP (Traffic Program) code report - enabled
by default
Analog input:
<
TuneByPrgTypeNumber >
Selects a PTN code (program type number) to
search. There are 31 different program categories
available for selection. The categories differ
depending on whether the tuner is in US or
European mode.
Valid values range from 1 to 31. Refer to the table
at the end of this topic for a table of codes and
their corresponding categories.
Setting this analog value to a valid PTN initiates
the search. The search operation stops when:
1) a station is found with the given category; or
2) the Tune, Scan, TA/TP Search, or Band mode
buttons are pressed; or
3) the maximum loop counter has been reached.
Sending a new analog value will cancel the current
search and initiate a new search.
(continued on next page)