Crestron C2N-TFM, Руководство по эксплуатации

Страница: 40 / 48

FM Radio Tuner Crestron C2N-TFM
36
•
FM Radio Tuner: C2N-TFM Operations Guide - DOC. 6233A
NOTE: The parameters shown in the previous illustration are the port settings for a
2-Series control system. Consult the Operations Guide for the control system being
used for exact parameter selection.
4. To verify communication, select Diagnostics | Establish
Communications (Find Rack) . This should display a window that
gives the COM port and baud rate. If communication cannot be
established, refer to the “Troubleshooting Communications” section in
the respective Operations Guide for the control system.
Uploading a SIMPL Windows Program
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system, .bin for CNX
generation, and .csz for CNX
generation with SIMPL+. The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window, navigate to the SIMPL
Window file (.smw), and click Open .
3. Select Project | Transfer Program .
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on
page 34 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P ) from the Viewport menu.
File Transfer | Send Program Command
3. The “Send Program” window appears, as shown after this step. Click
Browse , locate the compiled file (.spz for PRO2), and click Open . This
will display the program's header information and enable one or both of
the
What to Send check boxes. If the program does not contain any
SIMPL+ modules, only the SIMPL Program check box will be
enabled. If it does contain SIMPL+ modules, then the SIMPL+
Program(s) check box will also be enabled. Select one or both check
boxes and then click Send Program to begin the transfer.
NOTE: Refer to the respective Operations Guide for the control system for details
about the other fields shown on the “Send Program” window.