CRESTO RESQ Smartline X, Инструкция по использованию и карта осмотра

Страница: 21 / 23

© CRESTO Smartline X | EDITION 001/2017-­10-­02 | UK version (Master)
| 15
9. COMPATIBILITY, DOCUMENTATION AND COMPLIANCE
Every component used together with the Smartline X device should be identifiable as PPE
and CE-­marked, or show similar references to national rules and regulations outside EU
depending on place of use.
Body holding device
The Smartline X device may be used in combination with a sit-­harness to EN813, a full
body harness to EN361 or a rescue harness according to EN1497. It shall be attached to
the harness as recommended by the manufacturer..
Anchorages
The anchor sling may be used on constructions without permanently installed anchors. The
anchor sling should preferably be placed around bearing parts of the construction, and must
be able to support a minimum load of 12 kN. The karabiner may also connect directly to a
part of the structure as long as this part supports a load of 12 kN and does not cause
unintended strain on the karabiner.
If special designed anchors are used, these shall conform to EN795.
Log and documentation
This manual should always accompany the equipment . In the form on the last page, all
specific information about the equipment must be filled in if not connected to the Cresto
INSPECTOR data base. The user must fill in the dates for when the equipment has been
taken into use, and all periodic checks or repairs the equipment has been through. The
owner of the equipment is responsible for keeping this log updated, weather it refers to the
hard copy or the INSPECTOR file.
Compliance
As a manufacturer, CRESTO AB declares that their Smartline X device is in accordance
to the directive 89/686/EEC and that it is tested and approved in accordance with the
European standard EN 341 class D.
EC Type-­examination by: