ENGLISH
INSTRUCTION FOR USE
WARNING!
Wet battery charging produces highly explosive hydrogen gas.
Charge the battery in well-ventilated areas and away from naked flames.
Do not smoke while charging the battery.
Do not reinstall the recovery tank until the battery charging cycle is over.
WARNING!
Pay careful attention when charging WET battery as there may be battery fluid leakages.
The battery fluid is corrosive. If comes in contact with skin or eyes, rinse thoroughly with water
and consult a physician.
The steps to charge the battery:
1.
Open the recovery tank cap (24) to check if it is empty, if not, empty the tank first.
2.
Turn the power switch (45) to off position “
o
“.
3.
For WET battery only:
-
Check the battery electrolyte level, if necessary, full fill it.
-
Let all the battery covers open.
-
Clean the surface of the battery if necessary.
4.
Select one of below charging mode base on the charger type.
Use an external charger for battery charging
5.
The external charger output must be 24V DC, make sure use the suitable external charger.
6.
Connect battery connector to the charger and then connect charger to the supply mains.
7.
Disconnect the charger connector to the machine after charging is completed.
Use on-bard charger for battery charging
8.
Open the security cover of battery charger interface.
9.
Connect the end of the battery charging connector with the mains with a charging cable. (Please note the mains
must be Voltage 100 – 240V and frequency 50-60 Hz.) If the red warning light on the on-board charger
continues lighting, it shows that the charger is charging the battery.
10.
The Green LED (51) lighting indicates that the battery is full charged.
11.
Charging completed, disconnect the charging cable from supply mains and cover the security cover.
NOTE
For more on-board charger information (35), refer to relevant manual.
SQUEEGEE CLEANING
NOTE
In order to assure the drying result well, must keep squeegee blade cleaning and in good conditions.
CAUTION!
The operator must wear gloves for squeegee blade cleaning, because the squeegee blade may
contain some sharp fragments.
The steps to clean the squeegee blade:
1.
Drive the machine to the flat ground.
2.
Turn off the machine by turn the power switch (45) to off position “
o
”.
16
