2 of 3
LPN00501X0002A1_A
STEP 3:
Insert one side of the luminaire
housing into the mounting brackets
as shown in
Figure 3.
STEP 4:
Push up on the luminaire and then
press in on the mounting bracket
until the mounting bracket snaps into
place. See
Figure 4.
STEP 5:
Remove lens cover by unhinging
the latches and set cover aside to
reinstall later.
STEP 6:
Let the LED Tray hang down from
bracket. See
Figure 5.
STEP 7:
Insert customer supplied liquid tight
conduit and liquid tight conduit fitting
into desired conduit hole located on
the end of the housing. The dimension
of the conduit hole on the housing is
3/4” IP. Bring in customer supplied
cord and make wiring connections per
“Electrical Connection”
section. See
Figure 1.
NOTE:
Insert supplied plug into
unused conduit hole.
STEP 8:
Bring LED Tray back into housing and
secure by snapping in place using tray
brackets. See
Figure 6.
STEP 9:
Reattach lens cover removed in Step 5
and secure using latches.
NOTE:
If using tamper proof screws
(optional) insert screws into the (4)
latches located on the corners of the
housing before reattaching lens cover.
See
Figure 7.
4
Mounting Bracket
Mounting Bracket
3
(4) Corner Latches
7
6
Mounting Brackets
Tray Brackets
Tray
4
