3 of 3
CI350X01R1
www.cree.com/lighting
© 2014 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See
www.cree.com/lighting/products/warranty for warranty and specifications. Cree® and the Cree logo are
registered trademarks, and 304 Series™ is a trademark of Cree, Inc.
ELECTRICAL CONNECTIONS- PHASE TO NEUTRAL
WIRING – 120/277V
a. Connect the black luminaire lead to the line supply
lead
b. Connect the white luminaire lead to the neutral
supply lead
c. Connect the green or green/yellow ground lead to
the supply ground lead
ELECTRICAL CONNECTIONS- PHASE TO PHASE
WIRING – 208/240/480V
a. Connect L1 (Hot) supply lead to the black lead.
b. Connect L2 (Hot) supply lead to the white lead
c. Connect the green or green/yellow ground lead
to the supply ground lead
BLACK
OR L1 (HOT)
GROUND
LINE-BLACK
GROUND-GREEN
NEUTRAL-WHITE
SUPPL
Y WIRING
LUMINAIRE
WHITE
OR L2 (HOT)
ADJUSTING HEIGHT OF LUMINAIRE
If desired, the position of the luminaire can be adjusted as
follows:
STEP 1:
Remove set screw. See
Figure 7.
STEP 2:
Loosen adjustable knob. See
Figure 7.
STEP 3:
Rotate luminaire to desired position. Use the alignment slot to
align with a letter in the table, above, which will correspond to
the fixture degree (figure 6 is shown at 0 degrees)
STEP 4:
Tighten Adjustment Knob to hold luminaire in place.
STEP 5:
Insert Set Screw into hole that corresponds with the letter in
table on the left.
7
Adjustment Knob
Alignment
Slot
Set Screw
DEGREE
ADJUSTABLE FIXTURE
POSITION (FIGURE 2)
90
A
85
B
80
C
75
D
70
E
65
F
60
G
55
H
50
I
45
J
40
K
35
L
30
M
25
N
20
O
15
P
10
Q
5
R
0
S
