Configuring BlasterBoard Hardware 1-5
Step 2
One set of Slot 1 holders was installed on
your BlasterBoard; the two holders are
attached by screws. Lift up both of the
holders as shown
.
Step 3
Flatten the two latches on each side of the CPU. Insert the CPU into
the holders. Lock the two latches to secure the CPU.
If a Celeron CPU is installed, continue with the following step.
Step 4
After installing the CPU in the holders, push the retention locks downward to
secure the CPU card as indicated.
M009-1.fm Page 5 Wednesday, May 19, 1999 1:32 PM