6 3D Blaster™ RIVA TNT2™ M64
9. Connect the monitor cable to the VGA Out connector of 3D Blaster Riva TNT2 M64, as
shown in Figure 4.
10. Replace the computer cover and plug the power cord back into the wall outlet.
Installing
Software
After installing the graphics card, you can install the software. The 3D Blaster RIVA TNT2
M64 CD contains the following:
❑
Drivers for Windows 95/98 (common to both)
❑
Drivers for Windows NT 4.0
❑
Creative Enhanced BlasterControl
™
for Windows 95/98 and Windows NT 4.0
❑
Creative SoftMPEG for Windows 95/9
This section is organized as follows:
❑
To install in Windows 95 (Retail version)
❑
To install in Windows 95 (OSR version 2.0 and later)
❑
To install in Windows 98
❑
To install in Windows NT 4.0 (Service Pack 3)
• If you are using a multi-
frequency monitor, you may
need a special 15-pin
PS/2-compatible adapter
cable. If your multi-frequency
monitor allows you to switch
between ‘TTL’ and ‘analog’
operation modes, set the
switch to ‘analog’. For details,
refer to your monitor’s
manual.
Figure 4: Connecting your VGA monitor to the 3D Blaster RIVA TNT2 M64.
3D Blaster Riva TNT2 M64
VGA out
connector
VGA Monitor
VGA Monitor
cable
Содержание 3D Blaster GeForce 256 Annihilator
Страница 1: ...3D Blaster Riva TNT2 M64 Product Guide...