Assembly
60081-102 SWING BEAM
19860-100 Rev D (04-18)
© Copyright 2014, Creative Playthings, Printed in U.S.A.
Page 3
ASSEMBLY INSTRUCTIONS
STEP 4 – Beam Upright:
Use two 1/4 x 3" Hex Bolt Assemblies* to bolt the Front Up-
right (A) to the Back Upright (B) as shown at left.
Use 5/16" x 3" Hex Bolt Assemblies to join the Front Upright,
Back Upright, Swing Beam and Triangle Plate (G) as shown.
STEP 5 – Beam to Swing Mounts:
Fasten the L-Brace (H) to one of the Swing Mounts using
one 5/16 x 1-1/2" Hex Bolt Assembly through the bottom
hole of the brace as shown. Align the adjacent hole with the
upper hole in the Swing Mount.
It may be necessary to slightly loosen the bolts holding one
Swing Mount for the next procedure.
Lift the Beam into place. Align the hole at the
end of the Beam with the holes in the Swing
Mounts and L-Brace. Fasten using one 5/16
x 5-1/2" Hex Bolt Assembly as shown. Do
not tighten fully as it will be necessary to
pivot the Beam up into place in a later step.
STEP 6 – Beam Legs:
Fasten the Beam Legs (E) to the Front and Back Uprights us-
ing one 5/16 x 5-1/2" Hex Bolt Assembly. If the end of the Hex
Bolt protrudes more than two threads beyond the Weld Nut
add Flat Washers under the head of the Bolt.
Do not tighten fully as it will be necessary to pivot the Beam
into place in a later step.
5/16 x 5-1/2"
Hex Bolt
E
5/16 x 1-1/2"
Hex Bolt
Align top hole
5/16 x 5-1/2"
Hex Bolt
Swing Mount
H
1/4 x 3" Hex Bolt
5/16 x 3" Hex Bolt
A
B
G
* A Hex Bolt Assembly consists of
one Hex Bolt, one Lock Washer, one
Flat Washer and one Weld Nut.
