Assembly
© Copyright 2010, Creative Playthings. Printed in U.S.A.
MODEL PS10FRA
19766-100 Rev B (05-10)
3DJH
ASSEMBLY INSTRUCTIONS
67(3²/HIW6DQGER[6LGH
Fasten the Left Sandbox Side (Z) to the Left Corner Posts
with two 1/4" x 2" Hex Bolt Assemblies as shown. The Sand-
box Side rests on the Gym Base Rail.
STEP 23 – Rock Uprights and Ground Stake:
Loosely fasten the Access Ladder Brackets to the outside of
the Rock Climber Uprights (D) using one 5/16" x 1-1/2" Hex
Bolt Assembly each, as shown. Fasten each Access Bracket
to the gym using one 5/16 x 1-1/2" Hex Bolt Assembly.
Make sure that the Rock Climber Uprights are parallel to
each other and perpendicular to the gym. The lower corners
of the Uprights should be set into the play surface. Drive one
Ground Stake (O) into the ground along side a Rock Climber
Upright, as shown. The upper corner of the Stake should be
behind the top edge of the Upright to avoid interfering with
the Bottom Board in the next step.
Secure the stake with two #8 x 2-1/2" Wood Screws through
the pre-drilled hole.
Do not use concrete to set Ground Stakes. Pound a metal spike or
rod into the ground to start a hole in hard or rocky ground.
STEP 24 – Rock Boards:
/RFDWH WKH %RWWRP %RDUG $* DQG ÀYH 5RFN %RDUGV $)
Align the top of a Rock Board with the top of the Rock Up-
rights. Fasten the Rock Board using four #10 x 2" Wood
Screws. Continue the Rock Wall assembly by attaching Rock
Boards every 3-1/4". Alternate the position of the holes in the
Rock Boards as shown in the illustration. Finish by with the
Bottom Board in the lowest position.
1RWH'ULOODGLDPHWHUSLORWKROHLQWKH5RFN&OLPEHU8S
-
rights for each #10 x 2" Wood Screw.
Z
O
AF
AF
AG
AF
D
3-1/4"
