Assembly
© Copyright 2010, Creative Playthings. Printed in U.S.A.
MODEL PS10FRA
19766-100 Rev B (05-10)
Page 20
ASSEMBLY INSTRUCTIONS
Save all instruction sheets and receipts in case it becomes necessary to contact Creative Playthings
for warranty service and/or part replacement. The warranty can be found in your Owner
’
s Manual.
3OHDVHÀOORXWWKHZDUUDQW\FDUGRQWKHEDFNRI\RXURZQHUVPDQXDO<RXUFRPSOHWHGZDUUDQW\FDUG
will allow us to quickly process warranty claims.
Thank you.
STEP 34 – Ground Stakes:
Hammer two Ground Stakes (O) into the ground at the ends
of the Gym Base Rail. Place the Ground Stakes 6" to 9" from
each end and approximately 1/4" below the top edge of the
Base Rail. Hammer another Ground Stake next to the front
Access Ladder Rail as shown. Fasten each Ground Stake
using two #8 x 2-1/2" Screws through the pre-drilled holes.
Pound the last Ground Stake along the inside of the Front
Sandbox End, on the side farthest from the Gym Base Rail.
Secure the Stake with two #10 x 2" Screws.
1RWH'R127XVHFRQFUHWHWRVHW*URXQG6WDNHV6LPSO\
pound them in to the ground. Use a metal spike or rod to
start a hole in hard or rocky ground.
STEP 33 – Slide:
Center the Slide between the front Left Corner Post and
the Long Wall Slat. Pull it tight to the platform until it stops
against the front edge of the Platform End. Check that the
Slide extends out perpendicular from the play set.
Using the holes in the slide for guides, drill 5/16" holes
through the platform and secure slide using two 1/4" x 1"
bolts from the top and two weld nuts from below.
67(3²+DQJ6ZLQJV
Hang the Swings and Ring Trapeze as shown in the illustra-
tions.
7KHKHLJKWRIWKH6ZLQJVLVDGMXVWHGE\XVLQJDGLIIHUHQWOLQN
in the chain.
O
O
