Assembly
Pine Skybox
19690-100 Rev J (06-16)
© Copyright 2005, Creative Playthings
Page 13
ASSeMbly InStRuCtIonS
illustration #20
illustration #21
illustration #22
SteP 9 - narrow Platform boards:
Locate the two narrow Platform boards (W). Fasten the
narrow Platform boards (W) tightly against the Platform
Sides (W), resting on top of the Stringers (e & G) and
Platform Support (Z). Fasten the narrow Platform boards
(W) to the Stringers with six #8 x 2" Flat head Wood Screws
on each board.
SteP 10 - Platform boards:
Layout all the Platform boards (x) on the Stringers and
Platform Support. Space the Platform boards (x) evenly
between the narrow Platform boards (W). All of the Platform
boards should be placed flush to the edge of the Platform
Support. Attach each Platform board (x) using six #8 x 2"
Flat head Wood Screws.
W
y
y
x
SteP 11 - Post extensions:
Place the Right Post extension (i) against the right rear Gym
Corner Post, as shown. The top of the Right Post extension
should extend 3-1/2" beyond the top of the Gym Corner
Post. (if the Roof boards from the Gym keep the Right Post
extension from resting flat against the Gym Corner Post,
the Roof boards will need to be trimmed. Please review the
following two steps to determine the amount of trimming
needed.)
With a pencil mark the position of the Post extension holes
onto the Gym Corner Post. drill two 3/8" diameter holes
through the Gym Corner Post at the pencil marks. Fasten
the Right Post extension (i) to the Gym Corner Post using
two 6" hex bolt Assemblies.
Repeat with the Left Post externsion (h) and the left rear
gym Corner Post.
3-1/2"
i
h
