Assembly
© Copyright 2011, Creative Playthings
ManChester Fun DeCk
19807-100 rev D (07-16)
Page 12
Assembly InstructIOns
steP 9 – Gym Wall support:
to prevent sagging, do not put weight on the gym
while performing this operation.
replace the existing front Wall support with the
Gym Wall support (n). remove the original Wall
support. Connect the Gym Wall support to the
gym Post and Center Post using four of the 5/16
x 4" hex Bolt assemblies used for the original
part.
steP 10 – end ladder base rail:
Place the end Ladder assembly (X) with the side with the
screws that secure the rungs face up. Fasten the end Lad-
der Base rail (u) to the end Ladder assembly using two 3/8
x 4-1/2" Lag screws and two 7/16" Flat Washers. use the
pre-piloted holes on the end Ladder rails for alignment.
note that the Base rail projects further on one side than the
other. Be sure to orient the rail as shown.
steP 11 – side support:
Loosely fasten the side support (v) to the Base rail using
one 3/8 x 4-1/2" Lag screw and one 7/16" Flat Washer. use
the pre-piloted hole in the side support for alignment.
square the Base rail to the end Ladder assembly, then
swing the side support to rest against the adjacent end
Ladder rail. use a 1/4" diameter drill to create a 2-1/2" deep
pilot hole before fastening the side support to the Ladder
assembly using one 3/8 x 4-1/2" Lag screw and one 7/16"
Flat Washer. tighten all fasteners.
v
note: Your gym may in-
clude 3/8 x 4" lag screws
instead of 4-1/2" lags,
both will work.
u
X
note: Your gym may in-
clude 3/8 x 4" lag screws
instead of 4-1/2" lags,
both will work.
n
