FuN DECK SPIRAL SLIDE
19755-100 Rev E (07-16)
© Copyright 2009, Creative Playthings, printed in u.S.A.
page 7
AssEMbLy instructiOns
Ground Level
Anchor Nail
5/16 x 12"
stEp 17 - Anchoring run-off section
Drill two 5/16" holes through each side of the lower flange on
the Run-off Section. Hammer the two Anchor Nails into the
ground to anchor the front of the Spiral Slide.
NOTE: The Anchor Nails will hold better if they are driven in
at a slight angle as shown in the illustration.
stEp 16 - Lower slide support bracket
At the point where the Spiral Slide comes closest to the
Bracket Support (M), remove two of the hex bolts on the
Spiral Slide and attach the Lower Slide Support Bracket (H)
using the same hardware.
Mark the place where the holes on the Lower Slide Support
Bracket (H) encounter the Bracket Support. Drill 3/8"
diameter holes at the marks.
Attach the Lower Slide Support Bracket to the Bracket
Support using two 5/16 x 3" Hex Bolt Assemblies.
stEp 18 - bottom Filler and slide Mount
Locate the Bottom Filler (L) and Slide Mount (O). Place the
Bottom Filler against the Platform Support between the Side
Supports (J), as shown. Two edges of the Bottom Filler are
rounded. Be sure to place the Bottom Filler (N) with the
rounded edges up. If the Bottom Filler is too large for the
space, trim it to size with a saw.
Place the Slide Mount (O) tightly against the Bottom Filler.
Center the Slide Mount in front of the slide opening. Fasten
the Bottom Filler and the Slide Mount using the #10 x 2-1/2"
Wood Screws provided. Do not overtighten the screws.
Overtightening may cause the screws to protrude below the
Platform Boards.
Lower Slide
Support Bracket
Bracket
Support
L
O
J
