FuN DECK SPIRAL SLIDE
19755-100 Rev E (07-16)
© Copyright 2009, Creative Playthings, printed in u.S.A.
page 5
AssEMbLy instructiOns
stEp 10 - Entrance Assembly to Gym
Install the Entrance Assembly to the Gym through the two
holes in the Wall Support. Attach using two 5/16 x 3" Hex
Bolt Assemblies as shown.
Note: This step will require two people.
Fasten the bottom of the Entrance Assembly to the Gym
through the two holes in the Platform Support. Attach using
two 5/16 x 1-1/2" Hex Bolt Assemblies as shown.
Attach the Entrance Assembly through the top and bottom
two holes using four 5/16 x 1-1/2" lag screws and four 5/16"
flat washers.
Attach the side center three holes on both sides using six
5/16 x 2-1/2" lag screws and six 5/16" flat washers.
important: in any place where hardware penetrates a
peice of wood, use the gray "Xylan coated" hardware,
which has grater resistance to corrosion.
stEp 9 - slide Entrance Assembly
Assemble the Left Entrance Section to the Right Entrance
Section using fourteen 5/16 x 3/4" hex bolts, twenty-eight
5/16" flat washers and fourteen 5/16" Nylock nuts.
Attach the Entrance assembly to the Mounting Plate at
the four corners using four 5/16 x 1" hex bolts, eight 5/16"
flat washers and four 5/16" Nylock nuts as shown in the
illustration on the right. Make sure that the Nylock nuts are
installed to the outside away from the Gym.
NOTE: The Mounting Plate is stamped “TOP". Make sure
that it is positioned properly and that all of the holes around
the Mounting Plate line up before tightening.
Lag Screws
5/16 x 1-1/2"
Lag Screws
5/16 x 2-1/2"
Hex Bolt
5/16 x 3"
Wall Support
P
TO
Hex Bolts
5/16 x 1"
Mounting
Plate
stEp 11 - Assemble Elbow sections
Locate all of the Elbow Sections.
NOTE: The difference between the top and bottom sections
is the male and female flanges.
Assemble each of the two Elbow assemblies using thirteen
5/16 x 3/4" hex bolts, twenty-six 5/16" flat washers and
thirteen 5/16" Nylock nuts as shown in the illustration.
Assemble the remaining Elbow Section, Outlet Section and
the Lower Slide Bracket using thirteen 5/16 x 3/4" hex bolts,
twenty-six 5/16" flat washers and thirteen 5/16" Nylock nuts.
Platform
Support
Hex Bolt
5/16 x 1-1/2"
