AssEMbLy instructiOns
FuN DECK SPIRAL SLIDE
19755-100 Rev E (07-16)
page 6
stEp 12 - First Elbow
section
Position the first Elbow Section
directly under the Entrance
Section and rotate two holes off
center clockwise.
NOTE: There are male and
female flanges on all of the
sections. Make sure they match
properly.
Attach the two sections together
using twelve 5/16 x 3/4" hex bolts,
twenty-four 5/16" flat washers
and twelve 5/16" Nylock nuts as
shown in the illustration.
stEp 13 - second Elbow
Assembly
Repeat the procedure on Step
#10 but rotate the second Elbow
Section counter clockwise two
bolt holes. Attach using twelve
5/16 x 3/4" hex bolts, twenty-four
5/16" flat washers and twelve
5/16" Nylock nuts.
stEp 14 - Outlet Exit
Assembly
Repeat the procedure on Step
#11 and rotate the Outlet Exit
Section counter clockwise two
bolt holes.
Attach using twelve 5/16 x 3/4"
hex bolts, twenty-four 5/16" flat
washers and twelve 5/16" Nylock
nuts.
stEp 15 - run-off section
Install the Run-off Section to the
Outlet Exit Section using six 5/16
x 3/4" hex bolts, twelve 5/16" flat
washers and six 5/16" Nylock
nuts.
NOTE: Position Run-off Section
so that it is flat with the ground
surface.
Entrance
Section
1st Elbow
Section
2nd Elbow
Section
Outlet Exit
Assembly
Run-off Section
