EnderExtender.com – Ender Extender™ 5 Installation Guide
Page 22
Lightly tighten the M5 hex cap screws
attaching the rod mounting bracket to the
top frame member.
2
Attach the bottom rod mounting bracket to
the bottom frame member.
Center the part and snug the M5x20 hex
cap screws to ensure the bracket does not
move easily. You may have to loosen these
screws later for adjustment.
3
Position the assembled carriage plate over
the power supply, aligning the bearings
over the front and rear rod mounting
brackets.
4
Insert the front 10mm smooth rods
(560mm) through the bearings and into the
rod mounting bracket
