Crary CWS 1010, Руководство пользователя

Страница: 43 / 56

PN 26037-00 R072208 39
OPERATION
do use air to feed crop across the sickle.
do adjust air tube angle to maximize crop flow across
the sickle.
do use the reel to bring the crop to the header.
do make adjustments gradually.
do verify proper air position whenever adjusting reel height
or fore and aft position.
do ShuT off aiR immediaTelY if The aiR hoSe
Should fail. failuRe To do So maY ReSulT in
geaRbox failuRe.
do follow troubleshooting guide one step at a time.
do noT use more air than needed.
do noT operate with the air tubes on the ground.
do noT operate with plugged air tubes.
do noT operate with air hose disconnected.
5.7 opeRaTing hinTS
The following are recommended adjustments the operator can
make based on crop conditions. Any adjustments that involve
the operator leaving the combine cab should heed the warning
instructions listed below:
Increase air to maximum. 1.
Move tilt control until air is directed at back of sickle bar with 2.
reel feeding properly.
Gradually reduce air until crop is no longer flowing smoothly 3.
across sickle.
Gradually increase air until smooth crop flow across the 4.
sickle is achieved.
Remember: more air uses more horsepower. 5.
Gradually adjust air position fore and aft until optimum crop 6.
flow is achieved.
Gradually reduce air further until minimum air is used to 7.
maintain crop flow.
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRning
5.8 TRanSpoRTing
The CWS is designed to be easily and conveniently moved from
location to location. When transporting the machine, review and
follow these safety instructions:
Make sure you are in compliance with all local regulations 1.
regarding transporting equipment on public roads and
highways.
It is the responsibility to the owner to know the lighting and 2.
marking requirements of the local highway authorities and
to install and maintain the equipment to provide compliance
with the regulations. Add extra lights when transporting at
night or during periods of limited visibility.
See the owner’s manual that came with your combine and 3.
header for proper transportation guidelines.