Crary CWS 1010, Руководство пользователя, Страница: 14 / 56

PN 26037-00 R072208
10
ASSEMBLY
4.1 Reel aRm mounT
4.1.2 RighT hand
Bolt reel arm mount plates onto the OEM reel support bracket 1.
with two 1/2” x 1” bolts and nuts per plate. Mount as shown
in Figure 3.
Remove the lower OEM spacer located between the reel 2.
drive shield and shield support plate (Figure 4). It will not
be reused.
Place an arm mount tube between the reel arm mount plates 3.
and install it in the top hole with a 1/2” x 3” bolt, washers
and nut.
Insert the RH reel mount assembly into the arm mount 4.
tube.
Attach the notched end of the adjustment strap to the arm 5.
mount tube and the RH reel mount with a 1/2” x 3” bolt,
washers and nut. Install the strap with its notches pointing
down.
Attach the bottom end of the adjustment strap to the OEM 6.
reel support bracket by using the existing 1/2” hardware at
the front of the reel support bracket.
Ensure equal height of both LH and RH reel mounts. 7.
Figure 3, Reel arm mount (right hand)
Figure 4, Removing the OEM spacer