Crane Dixie-Narco 504 P Series, Техническое руководство

Страница: 5 / 99

INSTALLATION & SETUP P-SERIES
Page 5 of 99
The Dixie-Narco P-Series vender is designed
utilizing the latest technology.
UNPACKING THE VENDERS
Remove the stretch wrap and top cover from the
vender. Product cards are installed in the select
buttons.
DO NOT STORE THE VENDER
OUTSIDE WITH THE STRETCH
WRAP ON. THIS COULD CAUSE
THE STRETCH WRAP TO BOND
TO THE VENDER’S SURFACE,
WHICH COULD DAMAGE THE
FINISH.
Remove the shipping boards from the bottom of the
vender. The shipping boards are attached by the
leveling legs. To avoid unnecessary damage to the
leveling legs or base, remove the shipping boards by
using a 1½” “socket type” wrench to unscrew the
leveling legs. Be sure to replace the legs after
removing the shipping boards.
WARNING
TO AVOID THE POSSIBILITY OF A
FIRE HAZARD, DO NOT STORE
ANYTHING OR ALLOW DEBRIS OF
ANY KIND TO ACCUMULATE IN
THE BOTTOM OF THE DOOR, IN
AND AROUND THE
REFRIGERATION COMPARTMENT
OF THE CABINET, OR IN FRONT
OF THE EVAPORATOR AND
CONDENSER COILS.
ELECTRIC POWER NEEDED
Refer to the cabinet serial number plate to determine
the proper voltage and frequency the machine
requires (domestically this is 120 VAC, 60 Hertz).
The cabinet serial plate also indicates the Amperage
of the vender. The vender must be plugged into its
own properly rated single phase, alternating current
outlet with its own circuit protection (fuse / circuit
breaker).
DO NOT USE AN EXTENSION CORD.
POWER SUPPLY CORD and
GROUNDING REQUIREMENTS
In accordance with the National Electrical Code and
Underwriters Laboratories Inc., beginning April 10,
2006 all domestic vending machines are equipped
with a three-wire power supply cord and Ground
Fault Circuit Interrupter (GFCI). The GFCI device
is provided as part of the power supply cord and is
either incorporated directly into the plug or mounted
on the cord adjacent to the plug.
WARNING
•
The GFCI protects against current
leakage caused by ground faults.
The GFCI is not designed to
protect against over current or
short circuits.
•
DO NOT use the TEST and
RESET buttons on the GFCI as an
ON/OFF switch.
•
The vending machine supply cord
MUST be plugged directly into a
properly grounded, 3 wire
receptacle that is properly
protected by a fuse or circuit
breaker. If the receptacle will not
accept the power cord plug, it must
be replaced with a properly
grounded, 3 wire receptacle in
accordance with the National
Electrical Code and Local Codes
and Ordinances. The work should
be done by a qualified electrician.
DO NOT USE A 3 WIRE TO 2
WIRE ADAPTOR
DO NOT REMOVE THE
GROUND PIN ON THE PLUG OR
IN ANY WAY BYPASS, MODIFY,
DEFEAT, OR DESTROY THE
GROUNDING SYSTEM OF THE
VENDING MACHINE
•
DO NOT USE WITH AN EXTENSION
CORD.
•
DO NOT REMOVE THE WARNING TAG
ATTACHED TO THE POWER SUPPLY
CORD.
•
The GFCI must be tested frequently and before
each use in accordance with the instructions
provided on the GFCI device.
IF THE GFCI
DOES NOT PASS THE TEST, DO NOT USE
THE MACHINE
. Unplug the supply cord
from the receptacle and call the Dixie-Narco