Crane BARNES BUS Series, Инструкция по установке и эксплуатации

Страница: 4 / 16

4
Introduction
The Barnes Battery Back-up System
is a battery-operated sump pump. It
is de-signed as an emergency back-
up system to support your regular AC
sump pump, and it will automatically
begin pumping if your main AC pump
fails. Should any malfunction or
emergency occur that involves the
sump pump, the battery, or the AC
power, your battery back-up system
will sound an alarm and indicate the
nature of the problem and the solutions
by means of a lighted display on the
control panel.
The Back-up Sump Pump System
includes:
1 Control unit with a fl oat switch and a
battery
fl uid level sensor.
1 Pump with 1-1/4” PVC pipe adapter.
2 Plastic wire ties for mounting the
controller and the fl oat switch.
1 Battery cap for the sensor.
1 Battery
charger.
You will also need to supply:
A deep cycle marine battery (Do not
use a sealed or maintenance free
battery.)
1-1/4” & 1-1/2” PVC pipe and fi ttings
depending on the installation method
you choose
PVC cement and primer
A rubber union with hose clamps or
a “Y” connector and two (2) check
valves depending on the installation
method you choose.
For narrow sump pits you will need
some additional parts:
An “L” bracket at least 5 inches long.
(Preferably one that will not rust.)
Two (2) stainless steel hose clamps
One (1) stainless steel screw
(#8-32 x 1/4”), a matching washer & nut
Pump & Pipe Installation
Instructions
(Direct Discharge to
Outside)
There are two basic methods that can
be used to install the pump, (A) a direct
discharge to the outside of the building,
or (B) a hookup to an existing storm
sewer line.