51
Section 3.2: Programming Function Data
3.2.1 Customizing the Programming
Changing function data requires a few short steps. A password is required for changing
any function data in the Service or Advanced Levels. Changing data in the User Level
does not require a password. Figure 3.2.1 demonstrates how to change function data in
all levels.
Fig. 3.2.1: Programming Speed 1 frequency from 30.00 Hz to 45.50 Hz
Note: In this example, lowering the drive frequency will lower the top speed of the motor.
•
Press the PROG key. This places you in
the programming mode. The cursor will
appear on the lowest digit.
•
Press the SHIFT key once to move to the
next digit.
•
Press the UP arrow key 5 times.
•
Press the SHIFT key once to shift the cursor
to the next digit.
•
Press the UP arrow key 5 times.
•
Press the SHIFT key once to shift the cursor
to the next digit.
•
Press the UP arrow key once to change the
value of 3 to a 4.
•
Press the ENTER key to store the new
value.
USE
Speed 2
05
30.00 Hz
USE
Speed 2
05
30.00 Hz
USE
Speed 2
05
30.50 Hz
USE
Speed 2
05
30.50 Hz
PROG
USE
Speed 2
05
35.50 Hz
USE
Speed 2
05
35.50 Hz
USE
Speed 2
05
45.50 Hz
USE
Speed 2
05
45.50 Hz
ENTER
Get to the desired parameter you wish to change
listed in the Table 2.1. In this example, Speed 2 [USE:
Code No. 5] frequency located in the User Level
will be changed.
For more information contact: Sievert Crane and Hoist, (708) 771-1600, [email protected], www.sievertcrane.com
