8
Crane
Electronics Ltd
The force in torque management
Crane Electronics Ltd
Watling Drive
Sketchley Meadows
Hinckley LE10 3EY
Tel: +44(0) 1455 25 14 88
www.crane-electronics.com
Electrical Connections
The digital display module includes a USB/battery charger port as shown below:
DC Interface
- The interface for the 5V DC USB AC adapter is supplied with the WM10K. Use the adapter if you
plan on using the main power source.
Use only the AC adapter provided with the WM10K. If another power source is used it will void the warranty
and may cause severe damage to the digital display module.
USB Connections
- The USB interface cable shown below is used when downloading to a computer, or other
device. The values are sent every time a reading in Peak mode is taken on the WM10K.
Charging the Battery
- Follow the standard operating procedures in your workplace and be sure to observe all
communicated safety precautions.
-
The battery for the WM10K should last approximately 12 hours when fully charged.
-
The battery is charged any time the WM10K is plugged-in. The charge time is between 2 and 4 hours
depending on the battery charge level. It is recommended that the user unplug the unit when it is not in
use. This will not harm the unit and will increase battery life.
NOTE:
If the WM10K is stored for several months, ensure the battery is completely charged prior to storage.
