CraftUnique CraftBot 3 Supervisor, Руководство пользователя

Страница: 13 / 26

13
CraftBot 3
You can also use the “extrude” menu in the touchscreen to extrude filament out of the nozzle.
Re-insert the filament guide tube back into the hole at the top of the extruder. The two heads and the
build platform can now be set individually.
9. REMOVING THE FILAMENT FROM THE EXTRUDER
Never remove the filament from the extruder if the extruder is cold! Always preheat the extruder before
removing or changing filaments. Removing the filament from a cold extruder might damage it! You
don’t have to remove the filament between prints.
1. Heat up the extruder (see section 7)
Press the unload button. This will automatically extrude a small amount of filament to prevent
clogging and switch into reverse until filament removed from the extruder head.
2. Once the gears have begun to retract the filament you will be free to pull it out from the printer and
then load a new filament.
10. FMS OPERATION
The filament monitoring system observes the filament flow during printing. If the printer detects a jam during
printing, it will try to resolve it on its own. If it is unable to resolve the jam, then an error message will appear on
the display, the message will appear in the application, and the printer will also send an email message. Please
note, the wifi should be set up correctly first.
Calibration: Within the settings, touch the the encoder settings icon. Here you can view the status and
see whether the function is turned on or off. You can change this with the first button. You can provide
your email address with the @ icon, where the printer will send a message if it was unable to resolve
a jam. Calibration can be initiated by touching the icon resembling an A over a cog. You can set the
head temperature here. You can calibrate
the appropriate encoder with the help of
the first two icons. A test message can be
sent after calibration so the user can check
whether the email function is working. In
addition to the email, a message will also
appear in the application and on the FMS
reporting.