10
CraftBot 3
5. CONNECTING CRAFTBOT 3 TO A WIRELESS NETWORK
•
Select „Settings” on the LCD menu.
•
Navigate to the right with the arrow.
•
Choose Wi-Fi.
•
Select „search Wi-Fi network” icon – the left icon in the bottom
row.
•
Scroll down with up-down arrows. Select desired network with
the left arrow.
•
Enter password.
•
Confirm password with the tick mark in right bottom corner.
•
Selected Wi-Fi network is displayed indicating host name and LAN IP.
6. LEVELING THE BUILD PLATE
CraftBot has a leveling procedure which ensures that the extruder
and the heated build plate are at optimal distance and they must
be leveled evenly. Smaller gap or uneven levelling may lead to the
damaging of the Kapton cover of the build plate or the extruder.
•
Select „Settings” on the LCD menu.
•
Select the Leveling icon – three crossed circles which represent
the three knobs and screw.
•
Follow the step-by-step instructions on the LCD screen:
•
Turn all three black knobs holding the build plate all the way to
the right until the springs in between have been compressed fully
and the knobs begin to feel tight. (There is one knob at the front
in the middle and two in the back left and right corners of the
build plate). Do not force them!
•
Locate the 0.3mm spacer card in the top foam among the other
accessories. This card will ensure the optimal distance between the
build plate and the extruder. Please keep it for future use as well.
•
The preprogrammed leveling process will first set the front center
point. Place the spacer card above the front center black knob on
the build plate, then press the right arrow on the screen. Adjust
the front center knob if needed based on the instruction on the
screen.
•
Repeat the process with the two back knobs. First the right back,
then the left back knob will be adjusted.
•
Before switching from knob to knob, please remove and replace
the leveling card as necessary.
•
Process is repeated twice to make sure that all 3 knobs are in the
correct position.
•
As a result, the building plate should be evenly calibrated.
•
You can return to the main menu by pressing the right arrow.
Содержание CraftBot 3 Supervisor
Страница 1: ......
