TROUBLESHOOTING
18
WARNING
Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to prevent
unintended starting. Always wear safety glasses during operation or while
performing any adjustments or repairs.
This section addresses minor service issues. To locate the nearest authorized service center or to schedule service, simply call 1-888-331-4569.
Problem
Cause
Remedy
Engine fails to start
1 . Spark plug wire disconnected .
2 . Engine Throttle Control Lever incorrectly set .
3 . Fuel tank empty or stale fuel .
4 . Dirty air filter .
5 . Defective or incorrectly gapped spark plug .
6 . Misadjusted throttle control .
7 . Dirt or water in fuel tank .
1 . Reconnect wire .
2 . Put lever in START position .
3 . Fill tank with clean, fresh gasoline .
4 . Clean or replace filter .
5 . Clean, adjust gap, or replace .
6 . Contact an authorized service center .
7 . Contact an authorized service center .
Engine runs erratically
1 . Defective or incorrectly gapped spark plug .
2 . Dirty air filter(s) .
3 . Carburetor out of adjustment .
4 . Stale gasoline .
5 . Dirt or water in fuel tank .
6 . Engine cooling system clogged .
1 . Clean, adjust gap, or replace .
2 . Clean or replace .
3 . Contact an authorized service center .
4 . Replace with fresh gasoline .
5 . Contact an authorized service center .
6 . Clean air cooling system .
Engine overheats
1 . Engine cooling system clogged .
2 . Carburetor out of adjustment .
3 . Oil level is low .
1 . Clean air cooling area .
2 . Contact an authorized service center .
3 . Check oil level .
Engine does not shut off
1 . Misadjusted throttle control or ignition switch .
1 . Contact an authorized service center .
Wheels/Tines will not turn
1 . Improper use of controls .
2 . Worn, broken, or misadjusted drive belt(s) .
3 . Internal transmission wear or damage .
4 . Bolt loose in transmission pulley .
1 . Review Operation section .
2 . Replace or adjust belts .
3 . Contact an authorized service center .
4 . Tighten bolt .
Tines turn, but wheels don’t
1 . Bolt loose in transmission pulley .
2 . Internal transmission wear or damage .
1 . Tighten bolt .
2 . Contact an authorized service center .
Wheels turn, but tines don’t
1 . Tine holder mounting hardware missing .
2 . Bolt loose in transmission pulley .
3 . Internal transmission wear or damage .
1 . Replace hardware .
2 . Tighten bolt .
3 . Contact an authorized service center .
Poor tilling performance
1 . Worn tines .
2 . Improper Depth Regulator setting .
3 . Incorrect throttle setting .
4 . Forward Drive Belt slipping .
1 . Replace Tines .
2 . See “Tilling Tips & Techniques .”
3 . See Service & Maintenance Section .
4 . See Service & Maintenance Section .
Содержание CMXGVAM1144043
Страница 38: ...NOTES 38 ...
Страница 39: ...NOTES 39 ...
Страница 40: ...ProductManufacturedby Productofabricadopor MTDLLC P O BOX361131CLEVELAND OHIO44136 0019 ...