Craftsman CMXGVAM1144043, Инструкция по эксплуатации

Страница: 14 / 40

14
SERVICE AND MAINTENANCE
Engine Maintenance
Cleaning the Engine
CAUTION
Do not spray engine with water to clean because water could contaminate
fuel. Using a garden hose or pressure washing equipment can also force
water into the muffler opening. Water that passes through the muffler can
enter the cylinder, causing damage.
WARNING
Accumulation of debris around muffler could cause a fire. Inspect and
clean before every use.
If the engine has been running, allow it to cool for at least half an hour before
cleaning. Periodically remove dirt build-up from the engine. Clean around the
muffler. Clean with a brush or compressed air.
WARNING
Always stop engine and disconnect spark plug wire before performing any
maintenance or adjustments. Always wear safety glasses during operation
or while performing any adjustments or repairs.
General Recommendations
• Always observe all safety rules found on product labels and in this operator’s
manual when performing any maintenance. Safety rules can be found on the
product labels and in this Operator’s Manual beginning on page 3.
• The warranty on this tiller does not cover items that have been subjected to
operator abuse or negligence. To receive full value from warranty, operator
must maintain the equipment as instructed here.
• Some adjustments will have to be made periodically to maintain your unit properly.
• Periodically check all fasteners and make sure these are tight.
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks.
To schedule service from an authorized service center, call
1-888-331-4569.
MAINTENANCE SCHEDULE
WARNING
Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to prevent
unintended starting. Always wear safety glasses during operation or while
performing any adjustments or repairs.
Interval Item Service Service Log
Each Use 1. Engine oil level
2. Loose or missing hardware
3. Engine and around muffler
4. Air cleaner
1. Check
2. Tighten or replace
3. Clean
4. Check
1st 2 hours 1. Drive belt tension
2. Nuts and Bolts
1. Check
2. Check
Consult Engine Operator’s
Manual 1. Engine oil 1. Change
Every 10 hours 1. Drive belt tension
2. Unit
1. Check
2. Lubricate
Consult Engine Operator’s
Manual 1. Spark plug 1. Check
Every 30 hours 1. Tines for wear
2. Tire pressure
1. Check
2. Check
Consult Engine Operator’s
Manual 1. Engine oil† 1. Change
Consult Engine Operator’s
Manual 1. Air cleaner
2. Spark Plug
1. Change
2. Change
Before Storage 1. Fuel system 1. Run engine until it stops from lack of fuel
or add a gasoline additive to the gas in
the tank.