Craftsman CMHT77621, Руководство пользователя

Страница: 5 / 9

5
E
Contents
• Stud Sensor Information
• User Safety
• Battery Safety
• Installing AAA Batteries
• Using the Stud Sensor
• Maintenance
• Troubleshooting
• Service and Repairs
• Warranty
• Specifications
Stud Sensor Information
The Stud Sensor CMHT77620/CMHT77621 uses electronic signals
to locate the center of wood or metal studs, or live AC wires
through drywall or other common building materials.
PLEASE NOTE:
• The stud sensor will not detect objects in concrete, mortar,
block, brick work, plaster, carpeting, foil- faced materials,
metallic surfaces, or ceramic tile.
• The stud sensor is not designed to locate non-ferrous or plastic
objects, such as pipes.
Once the center of a wood or metal stud has been detected in one
pass across the surface, the Stud Sensor CMHT77620/CMHT77621
turns on an LED and sounds an audible tone. A marking hole
allows you to easily note the stud center
User Safety
Safety Guidelines
The definitions below describe the level of severity for each signal
word. Please read the manual and pay attention to these symbols.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in serious injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
If you have any questions or comments about this or any
CRAFTSMAN ® tool, go to http://www.CRAFTSMAN.com.
WARNING:
Read and understand all instructions. Failure to follow
the warnings and instructions in this manual may
result in serious personal injury.
SAVE THESE INSTRUCTIONS
WARNING:
The following label information can be found on your tool
for your safety.
CAUTION:
Protect your eyes. Wear safety goggles.
WARNING:
This tool is not a measuring device and should not be
used as a substitute for a voltmeter.
WARNING:
The LED or Live Wire Detection symbol on the display
is just an indicator and in some situations the voltage
detection option may not accurately indicate the
presence of voltage in a wall in the event of internal
device failure or improper operation, and therefore
should not be solely relied upon for identification of the
presence of hazardous voltages. Other evidence, such
as construction blueprints or visual identification of
wiring or conduit entry points should also be utilized.
Always follow proper safety practices and use a
separate detection method to verify a de-energized
condition prior to commencing work.
WARNING:
Always turn off AC power when working near wiring.
WARNING:
Shielded wires or wires in metal conduits, casings,
metalized walls, or thick, dense walls may not be
detected.