Craftsman C459-60116, Руководство оператора

Страница: 11 / 104

11
ASSEMBLY
CONNeCTINg THe BATTerY CABleS
WArNINg
Battery posts, terminals, and related accessories contain lead and
lead compounds, chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after handling.
CAUTION
When attaching battery cables, always connect the POSITIVE (Red)
wire to its terminal first, followed by the NEGATIVE (Black) wire.
To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The negative
battery terminal is marked Neg. (–).
Remove the plastic cover, if present, from the positive (+) battery 1.
terminal and attach the red cable to the positive battery terminal
(+) with the bolt and hex nut. See Figure 3.
Remove the plastic cover, if present, from the negative (–) battery 2.
terminal and attach the black cable to the negative battery
terminal (–) with the bolt and hex nut. See Figure 3.
Position the red rubber boot over the positive battery terminal to
3.
help protect it from corrosion.
NOTE: If the battery is put into service after the date shown on top/
side of battery, charge the battery as instructed in the Service and
Maintenance section of this Operator’s Manual prior to operating the
tractor.
Checking Tire pressure
WArNINg
Do not overinflate tires. Check sidewall of tires for maximum psi.
Equal tire pressure should be maintained at all times.
The tires on your tractor may be over inflated for shipping purposes.
Reduce the tire pressure before operating the tractor. Check sidewall
of tires for maximum psi.
Setting the Deck gauge Wheels
Move the tractor on a firm and level surface, preferably pavement, and
proceed as follows:
Select the height position of the cutting deck by placing the deck 1.
lift lever in the normally desired mowing height setting (any of the
six different cutting height notches on the right fender).
Check the gauge wheels for contact or excessive clearance with
2.
the surface below. The deck gauge wheels should have between
¼” and ½” clearance above the ground.
If the gauge wheels have excessive clearance or contact with the
surface, adjust as follows:
Raise the deck lift handle to its highest setting. a.
Remove the front and rear gauge wheels by removing the b.
lock nuts and shoulder screws which secure them to the
deck. See Figure 4.
Place the deck lift lever in the desired mowing height setting. c.
Reinsert the shoulder screw (with each gauge wheel) into d.
the index hole that leaves approximately ½” between the
bottom of the wheel and the pavement.
Refer to Leveling the Deck in the Service and Maintenance section
of this manual for more detailed instructions regarding various deck
adjustments.
Figure 3
Figure 4