Craftsman 235.185930, Руководство пользователя

Страница: 16 / 40

16
Trouble Probable Cause Solution
Low power Dry Motor Daily, inject 3 cc of Craftsman No.
18830 Oil into the inlet and run the
tool to lubricate the motor.
Inadequate air
supply Install proper air supply and connec-
tion. Refer to Figure 1 on Page 6.
Dirty Inlet bushing
Screen Using a clean, suitable, cleaning
solution in a well ventilated area,
clean the Inlet Bushing Screen.
Worn or broken
Vanes Replace a complete set of Vanes
Worn or broken
Cylinder and/or
scored End Plates Examine Cylinder. Check outside
and ends for wear or damage and
inside for scored or wavy bore. Re-
place Cylinder if any of these condi-
tions exist. Replace End Plates if
they are scored.
Dirty motor parts. Disassemble the Tool and clean
with a suitable, cleaning solution in
a well ventilated area. Assemble the
Tool and inject 3 cc of the recom-
mended oil into Inlet and run Tool to
lubricate internal parts.
Damaged Re-
verse Valve Replace Reverse Valve. Refer to
Installation of Reverse Valve.
Motor will
not run Incorrect assem-
bly of motor Disassemble motor and replace
worn or broken parts and reassem-
ble. Refer to Assembly of the
Motor.
Insufficient lubri-
cant in impact
mechanism. Lubricate impact mechanism
through Hammer Case Grease
Fitting using the recommended
grease.
Tool will not
impact Broken or worn
impact mecha-
nism parts Remove Hammer Case Assembly
and examine impact mechanism
parts. Replace any worn or broken
parts.
Impact mecha-
nism not as-
sembled correctly. Refer to Assembly of Impact
Mechanism.