Craftsman 137.322850, Руководство оператора

Страница: 36 / 52

36 37
QUICK-CAM MITER TABLE LOCK
OPERATION (FIG. GG)
If miter angles required are NOT one of
the nine positive stops, the miter table
can be locked at any angle between
these positive stops by using the quick-
cam miter table lock.
1. Unlock the miter table by lifting up
on the quick-cam miter table lock (1).
2. While holding the positive stop
locking lever (2) up, grasp the miter
handle (3) and move the miter table
left or right to the desired angle.
3. Release the positive stop locking
lever (2).
4. Press down on the quick-cam miter
table lock (1) until it locks the miter
table in place.
NOTE: The quick-cam miter
table lock should lock the table
and prevent it from moving. If
adjustment is needed, see the
section of “ QUICK-CAM MITER
TABLE LOCK ADJUSTMENT ”.
Fig. FF
1
Fig. GG
2
1
3
BEFORE LEAVING THE SAW
●
Never leave tool running
unattended. Turn power OFF.
Wait for all moving parts to stop.
● Make workshop childproof. Lock the
shop. Disconnect master switches.
Store tool away from children and
other unqualified users.
To avoid injury from materials being
thrown, always unplug the saw
to avoid accidental starting, and
remove small pieces of material from
the table cavity. The table insert may
be removed for this purpose, but
always reattach the table insert prior
to performing a cutting operation.
MITER CUT (FIG. HH)
The sliding compound miter saw is
equipped with nine positive miter
stops (1) on the saw base. The
locations are at 0, 15, 22.5, 31.6
and 45 degrees left and right. These
locations represent the most common
angles for cutting operation. To make a
miter cut:
1. Unlock the miter table by lifting up on
the quick-cam miter locking lever (2).
2. While raising the positive stop
locking lever (3) up, grasp the miter
handle (4) and rotate the miter table
left or right to the desired angle.
3. Release the positive stop locking
lever and set the miter at the desired
angle making sure the lever snaps
into place.
NOTE: The lever will only lock into
place at one of the nine positive stops.
WARNING
!