Craftsman 137.322850, Руководство оператора

Страница: 26 / 52

26 27
MITER SCALE (FIG. T)
The sliding compound miter saw scale
can be easily read, showing miter
angles from 0° to 47° to the left, and 0°
to 47° to the right. The miter saw table
has positive stops at most common
angle settings at 0°, 15°, 22.5°, 31.6°,
and 45°. These positive stops position
the blade at the desired angle quickly
and accurately. Follow the process
below for quickest and most accurate
adjustments.
Adjusting Miter Angles:
1. Lift up on the quick-cam miter
locking lever (1) to unlock the table.
2. Move the turntable while lifting up
on the positive miter stop locking
lever (2) to align the pointer (3) to
the desired degree measurement.
3. Lock the table into position by
pressing down on the quick-cam
miter locking lever (1).
Miter Angle Pointer Adjustment:
1. Move the table to the 0° positive
stop.
2. Loosen the screw (4) that holds
the pointer (3) with a Phillips
screwdriver.
Fig. S
1
3
2
3. Adjust the pointer (3) to the 0° mark
and retighten the screw.
ADJUSTING FENCE SQUARENESS
(FIG. U)
1. Loosen the four fence locking bolts (1).
2. Lower the cutting arm and lock in
position.
3. Using a square (3), lay the heel of
the square against the blade and the
ruler against the fence (2) as shown.
4. Adjust the fence 90° to the blade and
tighten the four fence locking bolts (1).
NOTE: If the saw has not been used
recently, recheck blade squareness
to the fence and readjust if needed.
5. After fence has been aligned, using
a scrap piece of wood, make a cut
at 90° then check squareness on
the piece. Readjust if necessary.
Fig. T
View from rear of machine
4
3
2
1
Fig. U
1
1
2
3