page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded part
of slotted holes in canopy cover with screwheads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
8. Blade Assembly.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Time Saver:
Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade plate up to blade [
Be sure to note label
on blade indicating
THIS SIDE UP
and turn
blade so that label faces up
.], aligning posts in
blade plate with holes in blade as shown, and
lower blade arm over blade holes. Insert 3
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (
save blade arm
screws and lock washers to secure blade arms
).
Align blade arm holes with motor screw
holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat with
remaining blade arms. Secure all screws.
Note
: Tighten blade arm screws twice a year.
screw
canopy
hanging bracket
screw
canopy cover
blade
motor housing
blade arm
lock washers and
blade arm screws
blade plate
blade
blade arm
blade attachment
screws and washers
