page 7
9. Switch Housing Assembly.
10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the pull chain. Start at the OFF position (no
blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull
will set the fan to LOW. Fourth pull will again set the
fan to OFF setting (
diagram 1
). If fan does not
function, please refer to "Troubleshooting" section
to solve any issues before contacting Customer
Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for
fan to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the
pull chain.
diagram 1
pull chain
extension
reverse switch
diagram 2
diagram 3
diagram 4
motor
housing
Remove 3 screws from outer edge of switch
housing plate (
save screws for later use
).
Remove 1 screw from fitter plate on underside of
motor and partially loosen the other 2 screws.
Align slotted holes in center of switch housing
plate with loosened screws in fitter plate, allowing
male plug from motor housing to come through
hole in middle of switch housing plate. Twist
switch housing plate to lock. Re-insert screw that
was removed and secure all screws.
Connect male plug from motor housing to female
plug from switch housing. Make sure plugs
connect tightly.
Align holes in switch housing with holes in switch
housing plate. Re-insert screws previously
removed and use a Phillips screwdriver to secure
all screws.
switch housing plate
fitter plate
motor housing
switch housing
male plug
female plug
