10
Optional Light Kit Installation
Remove three screws from side of switch hub (as shown in figure below).
Remove hub cover from hub and pop out center plug. Carefully thread
wires from light kit through the center hole in hub cover. At this point
attach light kit into hub cover by screwing center all-thread from light kit
into the center hub cover. Lock the all-thread in place on the inside of the
hub using the 3/8" nut provided. Attach white wire from light kit to white
wire in hub, using wire nuts. Next, attach black wire from light kit to blue
wire in switch hub. Carefully push wires up into hub and replace hub cover
using screws removed earlier.
Screws
Switch Hub
Center Hole
Center Screw
Remove Finial
8
Step 8
5 Blade Installation
Remove rubber cushions, saving motor
screws for blade installation. Using
motor screws (S6) provided, line up
holes from the blade arm with the holes
in the motor housing. Tighten screws
securely.
9
Modular Wiring Plug (A)
Mounting Plate (E)
Modular Wiring Plug (B)
Mounting Slots (D)
Switch Housing (4)
Screws
Step 9
1. To install the Switch Housing Assembly (4), locate both modular wiring
plugs (A) and (B). One extends from the mounting plate (E) on bottom
of fan body and one extends from the Switch Housing (4). Align the two
plugs so the latch on the side of the plugs will engage when pushed together.
Push the two plugs firmly together until latched.
2. Locate switch housing screws (S9). Raise switch housing cover (4) and
align the mounting holes with the holes on mounting plate (E). Once the
holes are aligned, attach the switch housing cover using the switch housing
screws (S9) and tighten firmly.
IMPORTANT:
Be sure that no wires are caught in mounting slots or pinched between
switch housing and mounting plate.
CAUTION
To reduce the risk of personal injury, DO NOT bend the blade arms when
installing them. When balancing the blades, or cleaning the fan, do not insert
foreign objects in between rotating fan blades.
