Preparation
Important:
When using an existing outlet box, be sure the box is securely attached
to the building structure and can support the full weight of the fan. Failure to do
so can result in serious injury or death.
4
Wire Connnections
Outlet Box
Fan wires
Black
Black
(Hot wire for fan)
Green Green
(Ground wire)
White
White
(Neutral wire)
Black
Blue
(Light kit wire)
Mounting Plate (1)
Fan Motor (2)
Black
Wire Connectors (S5)
White
Blue
Ground (Green)
"J" Hook (S9)
Step 4
Hang the fan motor/mounting bracket (2) onto the hook that is positioned
on the mounting plate (1).
1. Hang the fan motor (2) onto the hook that is positioned on the mounting
plate (1). Connect fan wires to ceiling wires: white fan wire to white outlet
wire, black to black and green to green. Wire connectors (S5) are provided
for your convenience. If an additional blue wire is present then also connect
the blue wire to the black wire. (Optional light kit may be wired to individual
wall switches, if desired.)
2. After connections are made, turn splices upward and push carefully into
outlet box. Separate blue and black wires on one side of the box, and white
and green wires on the other side.
There are 3 colored wires coming from the top of the motor (including
ground wire).
NOTE:
Wire connectors that are not pushed up into the outlet box may in time sag and
rub against the top of the motor housing. This sound can be mistaken for bearing noise.
Step 2
Check to make sure blades are at
least 30” from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
2
84”
(2.1m)
Min.
30”
0.75m
Min.
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
1
Warning:
Failure to disconnect power supply prior to installation
may result in serious injury or death.To reduce the risk of shock,
this fan must be installed with an isolating wall control/switch.
Step 3
Prior to securing mounting bracket, screw "J" hook (S9) into ceiling outlet
box as a secondary support means. Secure mounting plate (1) using screws
and washers (S2) directly to the outlet box. If not mounting to an outlet box,
use wood screws (S1) and mount securely to a beam or joist.
3
OUTLET BOX
Support Beam
Ceiling
Wood Screws
& Washers (S1)
Screws & Washers
for Mounting Plate (S2)
"J" Hook (S9)
Mounting Plate (1)
NOTE:
Do not mount directly
to sheet rock or ceiling tile.
NOTE: J Hook installation is a
Canadian requirement only.
