5
Step 5
For added security, attach safety cable from fan unit to "J" hook (S9) in
outlet box. Secure by looping zip tie (S10) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (1).
NOTE
: Parts furnished will allow you to install your fan at up to a 35
°
angle. Angles greater than 35
°
will require a 45
°
angle adapter (see dealer).
NOTE
: J Hook installation is a Canadian requirement only.
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
“J” Hook (S9)
Safety Cable
Zip Tie (S10)
“J” Hook (S9)
6
Step 6
Lift the fan motor housing (2) onto the mounting plate (1) and secure with
outer housing screws (S3).
Outer Housing (2)
Outer Housing
Screws (S3)
7
Step 7
For blade assembly, position blade holder (3), blade (5) so that all screw
holes are aligned (as shown in figure below). Using blade screws (S4),
insert through top of blade holder, through blade, and into blade ornament.
Tighten securely.
Blade Screws (S4)
Blade Arm (3)
Blade (5)
Motor
Screws (S6)
CAUTION:
Install blade holders to motor only after motor installation is complete. This
will prevent damage to the blade holders which have been carefully balanced.
IMPORTANT: Remove rubber cushions, saving motor screws for installation.
