6
Step 6
Setting Frequency Switches
The wall control unit is operated by a set of frequency switches and are
preset at the factory. There are two sets of frequency switches. The switches
on the wall control are located on the front panel under the insert plate.
The switches on the fan unit are located in the receiving module on top of
the fan unit (see diagram). The switches can be set in any position as long
as both the wall unit and receiving module switches are set the same. All
(RF) modules & Transmitters come from the factory with the dip switches
set in the (ON) position. Reattach top motor housing (#5) with the four
screws taken out previously.
Note:
In the event there are multiple remote units in an area, dip switches can be set to
different settings so one remote doesn't inadvertently turn on more than one fan.
1
2
3
4
ON
1 2 3 4
ON
OFF
12V BAT.
ON
HIGH
MED.
LOW
FAN OFF
L-1
L-2
REVERSE
1 2 3 4
ON
6
Helpul Hint
Remove fan motor (#5) from inside the box, turn the top foam insert
(#10) upside down, then lay the fan motor face down into the foam.
This will hold the motor housing steady during assembly.
5
Step 5
Take out the four screws in the top motor housing (#5). Save the screws.
Raise the top motor housing (#5) off the base (see figure 1). Slide blade
(#6) through slot on side of fan. Attach with blade screws (S4) as shown
in figure 2. Repeat this procedure until all five blades are secured. Tighten
firmly. Top motor housing will be reattached in following step.
Figure 1
Motor Housing (#5)
Top Motor Housing (#5)
CAUTION:
Never hold or lift fan by blades
Figure 2
Blade Screws (S4)
Top View
