page 13
11. Automated Learning Process./Activating Code.
wall control
faceplate
(almond
or white)
I
II
IV
VI
III
V
OFF
ON
SET button
faceplate
(black)
handheld
remote control
I
II
IV
VI
III
V
OFF
ON
SET button
CAUTION
:
The wall and/or handheld remote control can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
Restore electrical power and then, if using wall control,
set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press
and hold the fan
SET
button on the wall control for
5 seconds (or until light blinks twice or fan blades begin
to turn).
Turn power off again for at least 5 seconds
and then turn
power back on. Within 60 seconds of restoring the power,
press and hold the fan
SET
button on the handheld
remote control for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the learning
process is complete--
see Section 14.
Select a faceplate (
almond or white
) and press firmly onto
front of wall control that was previously installed to the
outlet box on the wall. [
Refer to
diagram 1
.
]
Attach
black faceplate
to front of handheld remote
control; press down firmly. [
Refer to
diagram 2
.
]
diagram 1
diagram 2
Fan
SPEED
control buttons--
1:
Use to control the ceiling fan speed 1-6
Fan
OFF
button--
2:
Use to turn the fan off
REVERSE
function button--
3:
Use to control fan direction
LIGHTING
button--
4:
Use to control down-light and/or up-light (if applicable)
ON
/
OFF
slider switch--
5:
[
Wall control only
] Use to turn wall control ON or OFF
IMPORTANT:
Handheld remote
control and wall
control must be
SYNCHRONIZED with
fan in order to
properly function.
handheld
remote control
wall control
4
3
1
5
I
OFF
ON
II
III IV
V
VI
2
12. Remote/Wall Control Operation.
I
II
IV
VI
III
V
4
1
2
3
IMPORTANT:
The Automated Learning Process takes approximately 5 minutes to complete.
Please
leave the
fan “ON”
for the duration of the 5-minute programming and
do NOT use the remote control or
turn off the power
during this time. The fan will
cycle through ALL SIX (6) speeds in forward
and reverse
and will
then stop automatically
after the learning process is complete.
