page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in center of fitter plate with loosened
screws in motor plate, allowing male plug
from motor housing to come through hole
in middle of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed
and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 3 screws from outer edge of fitter
plate.
Connect male plug from motor housing to
female plug from light kit fitter, matching up
the colors on the male plug with the colors
on the female plug for correct fit. Be sure
that plugs connect securely.
Carefully arrange wiring within fitter plate.
Align holes in light kit fitter with holes in
fitter plate. Re-insert screws that were
previously removed and tighten all 3 screws
securely.
To attach glass shade, align grooves on glass
shade with nodules on
inside
of light kit fitter
and push up gently on glass shade. Then,
turn glass shade to the RIGHT (clockwise)
until it no longer turns.
NOTE
: Pull down
VERY GENTLY
on glass
shade to make sure that glass shade is
secure.
motor plate
male plug
light kit fitter
motor
housing
fitter plate
female
plug
male
plug
motor
housing
light kit
fitter
glass shade
motor
housing
fitter plate
