page 9
9. Light Kit Assembly. (cont.)
Raise glass shade in order to guide pull chains
through holes at the bottom of the glass shade. Align
threaded rod on light kit fitter with hole in middle of
glass shade and push up gently allowing threaded
rod to come through hole. (Be sure pull chain for fan
operation does not rub against bulb during
operation.) Secure glass shade to light kit fitter with
threaded washer.
Note
:
Do not overtighten threaded washer as glass may
crack or break.
Thread pull chains through corresponding holes in
finial plate and center pull chain through hole in
finial. Tighten finial.
Note
:
Do not overtighten finial as glass may crack or
break.
Very gently
raise wire housing to switch housing
plate, aligning holes in the wire housing with the
holes in the 4 posts on the switch housing plate. [
Be
sure to avoid bumping the glass shade while raising it
as this may cause chipping or scratching of the glass
.]
Secure wire housing with 4 decorative nuts that were
previously removed. Tighten all 4 decorative nuts
securely.
wire
housing
decorative nuts
switch housing plate
finial plate
threaded washer
pull chains
finial
