7. Canopy Assembly.
page 7
8. Blade Assembly.
blade arm screws
lock washers
motor housing
blade arm
blade
blade attachment
screws and washers
hanging bracket
screw
screw
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then
tighten both screws securely.
canopy
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Time Saver
: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 12 blade attachment screws and
washers in hardware pack. Hold blade arm
up to blade and align holes. Insert 3 blade
attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (
save blade arm
screws and lock washers to secure blade
arms
). Align blade arm holes with motor
screw holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all
screws.
Note
: Tighten blade arm screws twice a year.
