page 8
receiver
9. Blade Assembly.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Locate 3 blade plates and 6 blade attachment
screws/washers in hardware pack.
Raise blade to motor, aligning holes in blade
with corresponding holes in motor.
[
Be sure to
note label on blade indicating
THIS SIDE UP
and
turn blade so that label faces up
]. Hold 1 blade
plate up to a blade, placing the flat side of the
blade plate against the blade, and align holes as
shown. Insert 2 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for remaining
blades.
Note
: Tighten blade attachment screws twice a
year.
blade
blade plate
motor housing
blade attachment
screws/washers
8. Canopy Assembly Installation.
Remove canopy assembly from j-hook
on mounting plate. Lift canopy assembly
to mounting plate and carefully push
wiring and wire connectors into outlet
box. Align slotted holes on top rim of
canopy assembly with loosened screws
in mounting plate. Twist canopy
assembly to lock. Re-insert the 2 screws
that were previously removed (page 4,
Section 4) and then tighten all 4 screws
to secure motor housing.
Locate 4 tabs
inside
housing ring. Align
tabs in housing ring with 4 screws at top
of canopy assembly. The tabs must fit
snugly
over
the screwheads to ensure a
secure fit.
NOTE
: It is recommended to
push one tab on at a time instead of
doing all four at once.
mounting plate
tab
slotted hole
canopy assembly
canopy ring