5. Fan Assembly.
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
page 5
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [
Refer to
diagram 1
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [
Refer to
diagram 1
.
]
Thread safety cable and electrical wires through end
of downrod and pull extra wire slack from the upper
end of the downrod. [
Refer to
diagram 1
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely.
[
Refer to
diagram 2
.
]
Slide yoke cover over downrod. [
Refer to
diagram 2
.
]
["Fan Assembly" continued on next page.]
diagram 1
diagram 2
motor
housing
downrod
electrical wiring
safety cable
yoke set screw
and nut
pin
clip
pin
clip
downrod
yoke
cover
motor
housing
